The AVFM 5.0 ultrasonic flow meter measures both level and velocity to calculate flow in an open channel or pipe. The meter can measure forward flow velocity up to 20 ft/sec (6 m/sec) and reverse flow up to 5 ft/sec (1.5 m/sec). The electronics and software sample and average flow rates continuously..
The AVMS 5.1 uses three submerged ultrasonic sensors to continuously measure both velocity and level in the channel. It is especially well-suited for channels wider than 6 feet or applications where velocity will vary across the width of the channel. By positioning three velocity sensors across the ..
Because the sensor is mounted on the outside of the pipe, it is unaffected by abrasives or harsh chemicals making it ideal for wastewater, slurries, sludge, chemicals, viscous liquids and abrasives. There is no obstruction to flow and no pressure drop. The DFM 5.1 is recommended for full pipes and a..
Recommended for difficult liquids including wastewater, cooling water, slurries, sludge, chemicals, viscous liquids and abrasives, the DFS 5.1 is ideal for pump protection or to activate flow/no-flow alarms.
The DFS 5.1 ultrasonic sensor can be mounted on the outside of any metal or plastic pipes f..
This versatility reduces costs and simplifies instrumentation and makes the DLT 2.0 a great solution for barscreen level control at wastewater treatment plants, pump stations and combined sewer systems.
The DLT 2.0 can measure both differential level plus flow through a flume. It includes two non-c..
The MantaRay displays and datalogs flow rate and total flow and connects to samplers, SCADA and telemetry systems.
The MantaRay uses a submerged ultrasonic sensor to continuously measure both velocity and level in the channel. From these measurements, both flow and reverse flow can be calculated. T..
The OCF 5.0 is easy to set up and operate. Use the built-in Keypad/menu system to select your flume or weir from the menu and to choose the measurement unit. Flow reports including minimum, maximum, average and total daily flow can be viewed directly on the backlit LCD display. The OCF 5.0 also incl..
Use the PDFM 5.1 for projects where a permanent flowmeter is not required or to temporarily replace installed flow transmitters.
The PDFM 5.1 non-intrusive Doppler ultrasonic sensor works with pipes from 1/2" to 180" in diameter. An acoustic pulse is reflected back to the sensor from particles or g..
The PT400 is recommended for clean liquids with less than 2% solids or gas bubbles. Since the transducers of the P400 are mounted on the outside of the pipe, there is no obstruction or pressure drop and they can be mounted without shutting down flow.
Calibrating the PT400 is easy with the onscreen ..
The PTFM 1.0 is is fast and easy to operate making it ideal for flow troubleshooting, balancing and checking performance of permanent flow meters. The non-contact transducers quickly attach to the outside of a pipe while the built-in keypad and calibration menu let you set up the instrument in minut..
The non-contact ultrasonic sensor mounts above the liquid being measured so it will not obstruct the flow nor be prone to fouling.
The SLT 5.0 is easy to set up and operate. Use the built-in 5-button keypad/menu system to input the calibration parameters and the SLT 5.0 will quickly calculate the v..
The Stingray 2.0 uses a submerged ultrasonic sensor to continuously measure both velocity and level in the channel. The sensor is a completely sealed ultrasonic unit with no orifices or ports. It is hydrodynamically shaped and designed to shed deposits and stringers for reliable operation in sewage,..